Jandy | JAOPX200 | X-Series X200 AOP Ozone and UV-C Pool Sanitizer, Up to 25,000 Gallons, 30 GPM, 110/240V

The Jandy X-Series X200 AOP System is an advanced oxidation sanitizer that pairs UV-C light with corona discharge ozone in one in-line, full flow unit. The two combine to make hydroxyl radicals, which break down oils, sweat, chloramines and organics that chlorine alone leaves behind. Rated for pools up to 25,000 gallons at 30 GPM, it runs on 110 or 240 volts and installs with two unions and three wires. Powered by DEL technology.

Key Features

• UV-C plus ozone in one unit: a low pressure, high output 254 nm UV-C lamp and one corona discharge ozone cell producing 200 mg/h.
• 11x the oxidation output of comparable AOP systems, per Jandy.
• Cuts chlorine demand: contaminants are destroyed on contact, so more free chlorine stays available and chloramine odor, eye sting and dry skin drop.
• NSF/ANSI/CAN 50 certified as a supplemental sanitizer with 99.9 percent reduction of Enterococcus faecium and Pseudomonas aeruginosa. UL listed for US and Canada.
• Full flow in-line design: 2 in PVC unions on inlet and outlet, no bypass loop or venturi required.
• Plug and play install: ozone generator and UV chamber come pre-plumbed and pre-wired in one cabinet.
• Dual voltage: 110 or 240 VAC, 50/60 Hz, auto sensing.
• 16,000 hour UV-C lamp life and roughly 5 year ozone cell life.
• NEMA 3 enclosure: indoor or outdoor, floor or wall mount, rated to Florida wind code category 1.
• Works with any primary sanitizer: Jandy TruClear, TruClear XL, TruChlor or a standard chlorine feeder.

Specifications

• Part Number: JAOPX200
• Max Pool Volume: 25,000 gal
• Design Flow: 30 GPM, NSF certified
• Ozone Output: 200 mg/h, 1 corona discharge cell
• UV-C Lamp: Low pressure high output, 254 nm, 16,000 h
• Voltage: 110/240 VAC, 50/60 Hz, single phase
• Current: 0.9 A
• Power: 99 W at 110V, 216 W at 240V
• Plumbing: 2 in PVC unions, inlet and outlet
• Dimensions: 24.3 in H x 12.5 in W x 13.4 in D
• Shipping Weight: 54 lb
• Enclosure: CSA/NEMA 3
• Certifications: NSF/ANSI/CAN 50 (CCS 16534), UL, cUL
• Related: JAOPX350 (40,000 gal), JAOPX500 (50,000 gal), JAOPXOFF (off-line), JMDVIN in-line mixing degas vessel
• Brand: Jandy

Frequently Asked Questions

Does this replace chlorine?

No. AOP is a supplemental sanitizer. You still need a primary residual sanitizer such as a salt chlorine generator or a chlorine feeder, but you will use much less of it.

What is the difference between the X200, X350 and X500?

Pool size and ozone output. X200 covers 25,000 gal at 200 mg/h, X350 covers 40,000 gal at 350 mg/h, X500 covers 50,000 gal at 500 mg/h. Pick the one rated above your pool volume.

In-line or off-line?

The X200 is in-line: all pump flow passes through it. If your pad has no room to cut in a full flow unit, the JAOPXOFF off-line model runs on a side loop instead.

Do I need the mixing degas vessel?

The JMDVIN is required on indoor and covered pools to strip residual ozone before water returns to the pool. On outdoor pools it is optional.

Will it work with my pump?

Yes, as long as flow through the unit stays at or above 30 GPM during the sanitizing cycle. Variable speed pumps should run at a speed that holds that flow while the AOP is on.

How often do I replace the lamp?

The UV-C lamp is rated 16,000 hours, which is 3 to 4 seasons at typical run times. Ozone cells last about 5 years.

Who should install it?

A licensed electrician or qualified pool professional. It is a 110/240 VAC line voltage appliance and must be bonded and wired to code.

What is the warranty?

Jandy manufacturer warranty. Register the system with Fluidra after installation and keep your receipt.

California Proposition 65 Warning: This product can expose you to chemicals known to the State of California to cause cancer and reproductive harm. For more information go to www.P65Warnings.ca.gov.